Programming The Immobilizer System - Gilera Fuoco 500ie LT Manual

Programming the immobilizer system

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
ISER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to «RUN».
START PROCEDURE
Insert the «MASTER» key into the switch (in "OFF" position), turning it to «ON» po-
sition. After 1 - 3 seconds, turn the key to "OFF" again and pull it out.
INTERMEDIATE STAGE
After extracting the «MASTER» key, insert, within ten seconds, the key that is going
to be programmed and turn it immediately to «ON» position. After 1-3 seconds, turn
the key to "OFF" again and pull it out. In this way, a maximum of 7 keys can be pro-
grammed by repeating the above procedure and keeping the indicated times.
FINAL STAGE
After extracting the key to be programmed, insert the «MASTER» key again and turn
it to «ON» position (perform this operation within the ten seconds following the ex-
traction of the previous key). Leave it in this position for 1 to 3 seconds and return it
to the «OFF» position.
CORRECT PROGRAMMING CHECK PHASE
Insert the «MASTER» key, disabling the transponder (i.e., by tilting the key cap by
90°), and turn the key to «ON» position. Perform the engine start-up operation. Ensure
that the engine does not start. Insert the programmed key and repeat the start-up
operation. Check that engine starts.
22