Operating Instructions; Putting Into Operation; Starting The Machine; Inserting Ferrules - Weidmuller Crimpfix 2.5 M Operating Manual

Stripping and crimping machine
7.

Operating instructions

7.1

Putting into operation

• Put in the stripping-waste container. Take care that the container is completely inserted.
• Connect the mains cable to the machine and to the electrical supply. (The data on the type plate must agree
with the mains supply.)
7.2

Starting the machine

• Actuate the main switch on the back side of the unit.
• The operating-menu appears on the display and the last selected program is loaded.
7.3

Inserting ferrules

• Open the flap.
• Release the locking pin (see Figure 3) and remove the magazine.
• Put on the ferrule reel, so that it rotates in clockwise direction.
• While inserting the ferrules, the transporting pusher must be retracted. If the pusher juts out, you have to
press it back.
• Insert the belt until the first ferrule is snapped in. Be careful that no ferrule sticks out of the magazine.
• If the locking lever was pressed, the transporting pusher must be retracted and the ferrule belt must be
reloaded again.
• Put in the magazine until it snaps in and close the flap.
Locking lever
Locking pin
Be careful that no ferrule sticks
out and the transporting pusher
is retracted while inserting
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
Figure 3: Magazine
Crimpfix 2.5 M
Locking lever
Tansporting pin
Tansporting pusher
8