Error Messages - Weidmuller Crimpfix 2.5 M Operating Manual

Stripping and crimping machine

11.1 Error messages

The error messages are shown on the display. The error messages are deleted by pressing key
Code Fault
Flashe. Saving or loading error
RS485-TO Timeout interface
S.motore Stepping motor at the limit stop or
blocked or timeout
Curr.e. Current to high
Machine is rough-running or blocked
Start=0 Wrong triggering
The starting switch S1 is activate
short.
Start=1 Start position error
Starting switcis used
Stop=1 Stop position=1
End position not reached
Stop=0 Stop position=0
Too much time for one cycle
Trash=0 No stripping waste container
Flap=0 Flap open
Service Message after 200 000 crimps
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
Elimination
Turn machine off and on or call the service.
Turn the machine off an on and choose the program
again.
3x M.Motor
E
Confirm → manual operation
5s
or Move carefully stepwise forwards or backwards
until the feeding funnel and the magazine are removable.
C
Starting position
Insert feeding funnel and fix it.
E
Exit and back to the operating menu
Insert the magazine.
Remove magazine
E
Press . The machine goes to the starting position.
Insert the magazine.
If you don't remove the magazine, the right treatment of
the ferrule can't be guaranteed.
3x M.Motor
E
Confirm → manual operation
5s
Press until the motor stops.
C
Starting position
E
Exit and back to the operating menu.
Insert in the magazine.
Insert the stripping waste container completely.
Close the flap.
The machine should be returned to the manufacturer for
any necessary maintenance work.
Crimpfix 2.5 M
E
.
17