Changing Stripping Blades; Changing Ferrule Cutting Blade - Weidmuller Crimpfix 2.5 M Operating Manual

Stripping and crimping machine

10.3.1. Changing stripping blades

• Stripping blades changing position
• See Figure 9: Stripping slide (backside)
• Remove the fixing screws of the blade fasteners
(1) at the stripping unit.
• Remove the blade fasteners.
• Loosen the fixing screws of the blades (2). Open
them for only 1 – 2 rotations but do not unscrew
them completely.
• Take out the blades.
• Put the new blades in correct position up to the
limit stop and screw them on.
• Mount the blade fasteners and screw them on.
Fixing screws
1 Blade fasteners
2 Blades
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
Danger! Blades are sharp.
2
1
Figure 9: Stripping slide (backside)

10.3.2. Changing ferrule cutting blade

• Stripping blades changing position
• See Figure 8: Striping blades changing position
• Remove the left, red marked screw (5) and the
protection plate (4).
• Unscrew both fixing screws of the table guidance
(9) from the back.
• Pull the table guidance (9) to the front down of the
two guiding pins and take it out to the right below
the magazine holder (6).
• Remove the flat head screw above the ferrule
cutting blade and change the blade.
• Take care that the ferrule cutting blade fits in the
groove and up to the limit stop before bolting the
flat head screw.
• Put the table guidance from the right side below
the magazine holder onto the lower slide. Push it
careful on the two guiding pins and screw it on
from the back.
• Fix the protection plate (4) with the red marked
screw (5).
Crimpfix 2.5 M
14