Trouble Shooting - Weidmuller Crimpfix 2.5 M Operating Manual

Stripping and crimping machine
11.

Trouble shooting

See chapter 3.8. Using risks
Trouble
Double crimp
Jammed wire
Not able to put in a cable
Machine is not starting
Wire is not stripped correct
Single strands are cut
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
Elimination
See Jammed wire
Remove the Magazine.
If there is a ferrule in the crimping tool, take it away.
Remove the feeding funnel.
If the feeding funnel is not removable:
3x M.Motor
E
5s Confirm → manual operation
or Move carefully stepwise forwards or backwards
until the feeding funnel is removable.
C
Starting position
Take out stripping waste.
Insert the feeding funnel and fix it.
E
Exit and back to the operating menu
Insert in the magazine.
Holding clamps are not in starting position
Remove the magazine
3x M. Motor
E
Confirm → manual operation
5s
C
Starting position
E
Exit and back to the operating menu
Insert in the magazine.
Machine is not in operating mode
Remove the magazine
3x M. Motor
E
Confirm → manual operation
5s
Insert wire
Starting switch S1 is triggered (*) or damaged.
C
Starting position
E
Exit and back to the operating menu
Insert in the magazine.
Stripping depth is not adjusted correctly.
See chapter 9.2 Adjusting Stripping Depth
Stripping depth is not adjusted correctly.
See chapter 9.2 Adjusting Stripping Depth
Crimpfix 2.5 M
15