Weidmuller Crimpfix 2.5 M Operating Manual page 16

Stripping and crimping machine
Display is not readable
Key presses are not accepted
Ferrule misses on the stripped wire
Wire is not stripped tough the machine is correct
adjusted
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
Contrast setup is not ok.
Mains switch +
Edit
E
Exit
Keyboard is damaged
Keyboard check
C
Main switch and
0c
0e
C
0f
E
0d
Open the flap and remove the magazine.
If there is a ferrule in the ferrule holder take it out.
Insert the magazine and close the flap.
Turn off the machine and wait 30 s.
Start the machine and make a stripping test.
(see chapter 7.6)
Crimpfix 2.5 M
Back to main menu
16