Special Functions; Display Contrast; Adjusting Stripping Depth; Maintenance - Weidmuller Crimpfix 2.5 M Operating Manual

Stripping and crimping machine
9.

Special functions

9.1

Display Contrast

Mains switch +
Edit
E
Exit
9.2

Adjusting Stripping Depth

Remove the magazine
Close the flap
2x S-Motor
E
Press it 5 seconds till cursor
starts blinking
Reduce D
depth
or
Enhance D
depth
E
Confirm and back to the
operating menu
Check the stripping quality after changing the
stripping depth. (Chapter 7.6)
The adjusted guide values
depend on wire type and wire
manufacturer and can be used
for new intact striping blades.
10.

Maintenance

See chapter 3.8. Using risks

10.1 Stripping-waste container

• Regularly empty the stripping-waste container.

10.2 Interior

• Switch off the machine and unplug it.
• Remove the stripping-waste and other impurities
• Do not clean with compressed air.
• Do not oil and/or lubricate the machine.
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
a
=
b
enhance cutting
reduce cutting
The cut edge of the stripping blades have to look like a rue
and must be symmetrical to the stranded wires
Program Cross section
1 0,34 mm²
2 0,5 mm²
3 0,75 mm²
4 1,0 mm²
5 1,5 mm²
6 2,5 mm²
3
1
Figure 7: Top view of a correct stripping
Diameter Wire type
1,20 mm LiY
1,40 mm H05V-K
1,60 mm H05V-K
1,80 mm H05V-K
2,10 mm H07V-K
2,45 mm H07V-K
Crimpfix 2.5 M
Cutting edge of the stripping blades
Stranded wires
Isolation
Wire manufacturer
LAPPKABEL
12