Striping Blades Changing Position - Weidmuller Crimpfix 2.5 M Operating Manual

Stripping and crimping machine

10.3 Striping blades changing position

4
5
6
7
8
9
→ Striping blades changing position
• Remove the magazine
• Unscrew and remove the feeding funnel
• 3x
M.Motor
E
•
5s Confirm
C
•
Starting position
•
Press until Motor stops.
• Switch off the machine and unplug it.
• Remove the stripping waste container
• Unscrew and remove the reel holder
• Unscrew and remove the flap
• Remove the cover. (Screws at the bottom plate
and at the line filter)
• Remove right, red marked screw (3).
• Push the shaft (1) to the front and remove it.
• Loosen the plug connection at the S-Motor (8).
• Remove the two fixing screws of the key
attachment (10) and take it out to the front with
the key.
• Turn the stripping slide (7) to the left.
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
Figure 8: Striping blades changing position
• Take care that the pin at the bottom side of the
• Push the shaft (1) back and fix it with the right, red
• Assembly the cover, the reel holder and the flap.
• Put the stripping waste container in.
• Put the machine into operation again.
• 3x
•
•
•
• Put in the magazine again.
• Control the stripping quality.
3
2
1
1
2
3
4
5
6
10
7
8
9
10
attachment
→ Basic position
stripping slide (7) snaps into the groove (2) of the
driving lever when it swings back.
marked screw (3). Take care that the screw (3)
snaps into the groove of the shaft(1).
M.Motor
E
5s Confirm
C
Start position
E
Quit menu and back to main menu.
Crimpfix 2.5 M
Shaft
Groove – driving lever
Right screw, red marked
Protection plate
Left screw, red marked
Magazine holder
Stripping slide
S-Motor
Table guidance
Fixing screw – key
13