FANATEC CSL Elite Racing Wheel Manual page 41

Problem description
The tuning display does not show anything or is
not working properly.
After switching on the CSL Elite Racing Wheel the
auto calibration is not working properly.
After playing a while the CSL Elite Racing Wheel
seems to become weaker or is fading.
After playing a while the CSL Elite Racing Wheel
motor has switched OFF.
Fan is always working in full speed even though
the CSL Elite Racing Wheel was just powered ON
and did not heat up due to driving yet.
After calibration run at startup of CSL Elite Racing
Wheel the attached steering wheel doesn't go to
correct centre position.
41
Solution
Try to use another steering wheel. If this is also
not working properly the CSL Elite Racing Wheel
might be damaged.
Check the pins inside the quick release of the
steering wheel, these must not be bent or dam-
aged.
Make sure that you have updated your CSL Elite
Racing Wheel to the latest firmware version which
can be downloaded from the Downloads section
of the Fanatec website www.fanatec.com.
When the motor temperature is close to the upper
limit the Tuning Menu values will be overwritten to
regular maximum values (not higher than 100%).
Additionally, the motor power level is controlled by
firmware so that the FFB strength may fade in this
high temperature range but the motor will not be
damaged. This allows extending the duration of
driving before the motor has to completely stop
operating.
Let your CSL Elite Racing Wheel cool down be-
fore continuing use.
When the temperature is exceeding the upper lim-
it the motor will be deactivated for a while until the
temperature is low enough (to protect the hard-
ware from damages).
Let your CSL Elite Racing Wheel cool down be-
fore continuing use. Contact our customer sup-
port if this happens consecutively.
In case of malfunctioning temperature sensor the
fans will work at maximum speed to protect the
hardware from overheating. Please contact our
customer support. Note: The room temperature
should be above 20°C.
Please check your Tuning Menu settings, the val-
ue for SPR (spring) must be higher than '000' as
this effect is required to make correct centring.
Default value is '100'.