FANATEC CSL Elite Racing Wheel Manual page 32

6.3.7 FOR (force), SPR (spring), DPR (damper)
FOR range: OFF
SPR range: OFF
DPR range: OFF
These force feedback modifiers give you the ability to change the force feed-
back signals of a game (only applicable if game uses these effects). In theory
there are three types of signals which a game can send: Force (pushes the
wheel in a specific direction), spring (pulls the wheel towards the dynamic cen-
tre) and damper (creates friction). Not every game uses all types of effects and
some games even use only one type to create all different feelings. Using your
Tuning Menu in the CSL Elite Racing Wheel you can increase or reduce these
different effects individually. To change the active value, move the directional
stick of the Fanatec
Note: If SPR is set to low values or 'OFF' the CSL Elite Racing Wheel will not
be able to move the attached steering wheel to the correct centre position after
calibration run.
IMPORTANT:
back effects are clearly not strong enough and weaker in comparison to
other games. When the game sends full effects and the wheel is set to
100% then the device will work on its power limit. Pushing up one value
to a very high number or even raising multiple values will result in higher
load on the motor and increased heat generation.
For further information check the FAQ section on our website
www.fanatec.com/support.
32
010 ... 120
010 ... 120
010 ... 120
steering wheel up or down.
®
Only set these values higher than 100% if the force feed-
FOR default: 100 (%)
SPR default: 100 (%)
DPR default: 100 (%)