After-Sales Service - KitchenAid KCBPX 18120 Instructions For Use Manual

FAILURES
In the event of operation alarms, they will also be displayed in the digits LEDs, (e.g. Failure 1, Failure 2,
etc...) call After‑sales Service and specify the alarm code. The acoustic alarm sounds, the Alarm icon
lights up and the F letter on the digit display blinks according to failure code described below:
Failure code
Error 2
Error 3
Error 6

After-sales service

Before contacting After-Sales Service:
Switch the appliance on again to see if the problem has been solved. If it has not, disconnect the
appliance from the power supply and wait for about an hour before switching on again.
If, after performing the checks described in the Troubleshooting Guide and switching the appliance on
again, your appliance still does not work properly, contact the After‑sales Service, explain the problem.
Specify:
• the model and appliance serial number (stated on the rating plate),
• the nature of the problem,
• the Service number (the number after the wordSERVICE on the data
plate on the inside of theappliance),
• your full address,
• your telephone number and area code.
Note:
The direction of door opening can be changed. If this operation is performed by After-sales
Service it is not covered by the warranty.
Visualization
F letter blink on/off at 0,5 sec.
Blinks ON 2 times then remain off for 5 seconds.
Pattern repeats.
F letter blink on/off at 0,5 sec.
Blinks ON 3 times then remain off for 5 seconds.
Pattern repeats.
F letter blink on/off at 0,5 sec.
Blinks ON 6 times then remain off for 5 seconds.
Pattern repeats.
18
x2
x3
x6