Safeguarding The Environment; Before Using The Appliance - KitchenAid KCBPX 18120 Instructions For Use Manual

Safeguarding the environment

1. Packing
The packing material is 100% recyclable and bears
the recycling symbol
the local regulations. Keep the packing materials
(plastic bags, polystyrene parts, etc.) out of the
reach of children, as they are a potential source of
danger.
2. Scrapping/Disposal
The appliance is manufactured using recyclable
material.
This appliance is marked in compliance with
European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE). By ensuring the
correct disposal of this appliance, you can help
prevent potentially negative consequences for the
environment and the health of persons.
The symbol on the appliance, or on the
accompanying documents, indicates that this
appliance should not be treated as domestic
waste but must be taken to a special collection
centre for the recycling of electrical and electronic
equipment. When scrapping the appliance, make
it unusable by cutting off the power cable and
removing the doors and shelves so that children
cannot easily climb inside and become trapped.

Before using the appliance

To ensure best use of your appliance, carefully
read the operating instructions which contain
a description of the product and useful advice.
Keep these instructions for future reference.
1. After unpacking the appliance, make sure
it is not damaged and that the door closes
properly. Any damage must be reported to
the dealer within 24 hours of delivery of the
appliance.
. For disposal, comply with
Scrap the appliance in compliance with local
regulations on waste disposal, taking it to
a special collection centre; do not leave the
appliance unattended even for a few days, since it
is a potential source of danger for children.
For further information on the treatment,
recovery and recycling of this product, contact
your competent local office, the household
waste collection service or the shop where you
purchased the appliance.
Declaration of conformity
• This appliance has been designed for preserving
food and is manufactured in compliance with
Regulation (CE) No. 1935/2004.
• This appliance has been designed, manufactured
and marketed in compliance with:
‑ safety objectives of the "Low Voltage" Directive
2006/95/CE (which replaces 73/23/CEE and
subsequent amendments);
‑ the protection requirements of Directive "EMC"
2004/108/EC.
2. Wait at least two hours before switching the
appliance on, to ensure that the refrigerant
circuit is fully efficient.
3. Clean the inside of the appliance before using
it.
6