Table of Contents
Advertisement
7. Electrical Diagram
The following diagram shows the internal electrical circuit of the water tap. It is provided
for reference only.
Never attempt to modify the internal wiring the electric water tap. Doing so is potentially
dangerous and will void the appliance's warranty.
8. Installation Guidelines
Make sure the appliance is fully intact and all fittings are complete.
•
Make sure the power supply, grounding and cabling meet the specified requirements.
•
Make sure the water pressure on the water supply line meets the specified
•
requirements.
Before installing and using the appliance, make sure there are no blockages in the
•
water inlet or drain pipes.
It is recommended to use stainless steel braided flex piping.
•
Never solder the pipes or fittings.
•
Before connecting to the power supply, you must complete all mounting and plumbing
•
connections, and test the water supply. Make sure water flows sufficiently and evenly.
Make sure there are no leaks.
Connect the tap's power cable to a grounded power outlet. The outlet must be
•
connected directly to a dedicated, grounded circuit breaker on the main electrical panel.
9. Installation
The HOTAP instant water heater tap can be installed in either of two ways.
Option 1: The power cable runs from the tap to a power outlet below the counter.
In this option, only the bottom part of the pedestal is required.
Option 2: The power cable runs from the tap to a power outlet above the counter.
In this option, both the top and bottom parts of the pedestal are required.
Complete all mounting and plumbing connections before connecting to the
power supply.
8
Operating the tap without a water supply may cause damage to the appliance
and will void the warranty.
Advertisement
Table of Contents
