Page 1
Hot Water on Demand Installation and Operation Guide COMFORTAP/HOTAP Water Heater Faucet COMFORTAP 1.8kW HOTAP 3.0kW www.atmorusa.com Cat. No. 197575...
Page 2
Important Safety Guideline SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. Definitions: Safety Alert Symbols and Words This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
By installing this product, you acknowledge the terms of the manufacturer’s warranty and authorized dealer’s return policy. Once the faucet is installed, do not return the product to the place of purchase. If you have any questions regarding the warranty or the product return policies, contact Atmor by phone or email.
1. Packing List Item Quantity Instant water heater tap ½" ½" Fixture disk Rubber pad Mounting nut ½" Water inlet hose BSP ½" * NPT ½" ½" Ghid de instalare si functionare...
2. Safety Instructions For your satisfaction and safety, read this guide thoroughly before installing and using the HOTAP water heater faucet. For best performance, we recommend this appliance be installed by a licensed electrician and in accordance with all electrical and plumbing codes applicable to your area, and as specified in this guide.
• Make sure the hole through the counter is large enough for the electric cable to pass freely through it. The cable should also pass easily through the notches in the pedestal and rubber pads, as shown in the installation diagrams. Failure to install the electric cable properly could cause the wires to fray, which will void the appliance’s warranty.
5. Technical Specifications Item Specification COMFORTAP HOTAP Power 1.8 kW 3 kW Hot water flow rate 3 bar 0.7 – 1.5 gallon/minute Voltage 120 V Rated current 15 A 25 A Rated frequency 50/60 Hz Recommended cable size 12 AWG...
8. Installation Guidelines • Make sure the appliance is fully intact and all fittings are complete. • Make sure the power supply, grounding and cabling meet the specified requirements. • Make sure the water pressure on the water supply line meets the specified requirements. •...
Page 10
Cable over sink installation Position the appliance upright with plumbing connections facing down. 1. Line up the Fixture disk and rubber pad. (Fig. 1) 2. Feed the faucet’s water pipe through the hole. (Fig. 2) 3. Line up the rubber pad and pedestal. (Fig. 3) 4.
Model COMFORTAP 1.8kW Make sure the faucet handle is in the OFF position. Then plug the electric cable into the power outlet.(Fig. 8b) 9. After completing the plumbing and electrical installation, and when operating the appliance for the first time, allow cold water to flow through the faucet for at least 20 seconds to flush the water line of any debris.
This warranty is valid only if product is purchased from an authorized reseller. Atmor warrants to the original owner that our instant electric hot water faucet will be free from defect in workmanship and material for a period of ONE YEAR from the date of purchase.