Set Lc Controller Date And Time; Configure Sensors - Bard MEGA-TEC W090A Service Instructions Manual

LC6000 Controller Display and Interface (Status Screen Shown)
ALARM KEY
MENU KEY
ESCAPE KEY
LC6000 interface key functions are the same as those shown for the TEC-EYE in Figure 30 on page 32.
The Status screen on the LC6000 displays the current
date, time, unit displayed, zones and system status
(see Figure 34).

4. Set LC Controller Date and Time

1) Press MENU key to access the Main Menu
screen.
2) Use UP or DOWN keys and ENTER key to
enter USER password 1313.
3) Press the UP or DOWN keys to scroll to the
Settings menu; press ENTER key.
4) Press UP or DOWN keys to scroll to Date/Time
menu; press ENTER key.
5) Press UP or DOWN keys to scroll to Date/Time
change.
6) Press ENTER key to scroll to the desired value
to be changed (see Figure 35).
FIGURE 35
Setting Controller Date and Time
7) Press UP or DOWN keys to change the value.
8) Press ENTER key to save and to scroll to top of
screen.
9) Press UP or DOWN keys to scroll to Timezone
(if applicable). Follow steps 6-8 to change
timezone.
10) Press ESCAPE key several times to return to
Main Menu screen.
FIGURE 34
NOTE: The LC6000 will sync the time and date
configured to each of the wall-mount units once
communication is established.

5. Configure Sensors

The system will need to be configured for the
number of temperature and humidity sensors
installed. The system is shipped with one
combination temperature and humidity sensor.
Additional combination sensors may be purchased
or alternatively, temperature-only sensors may be
purchased instead. The LC is capable of supporting
up to four indoor temperature sensors (two in zone
1, one in zone 2 and one in zone 3), three indoor
humidity sensors (one per zone ), one outdoor
temperature sensor and one outdoor humidity
sensor. The system will need to be configured for
the various configurations.
If necessary, the sensors could be calibrated at this
time too. For information on calibrating the sensors
(adjusting the offset), see page 40.
To enable/disable Zone 1 Indoor Humidity:
1) Press MENU key to go to the Main Menu
screen.
2) Press UP or DOWN keys and ENTER key to
enter USER password 2000.
3) Press UP or DOWN keys to scroll to IO Config;
press ENTER key.
4) Press UP or DOWN keys to scroll to Z1 Indoor
Hum C4.
5) Press ENTER key to scroll to Enable (see
Figure 36 on page 36).
6) Press UP or DOWN key to change value to ON
to enable sensor (or change value to OFF to
disable sensor).
UP KEY
ENTER KEY
DOWN KEY
Manual 2100-705B
Page 35 of 43