Replacing Items - Removing Left Side Cover Required - TurboChef i5 Service Manual

Replacing Items - Removing Left Side Cover Required (Figures A-7, A-8)
DANGER: Before replacing any oven component, ensure the oven is removed from any power
source. Replacing a component while the oven is plugged in can result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the
wire harness (where applicable).
CAUTION: Be careful to not tear the insulation when servicing components. Always reset the
insulation properly before reinstalling the side panel.
NOTE: Hardware listed is required for installing component to oven.
To remove the left side cover, remove the screws securing the panel to the oven frame. To re-install the left
side cover, you may need to open the top cover (see page A-5).
Figure
Item Description
Reference #
1 Blower Motor (top)
2 Blower Motor (bottom)
3 Blower Wheel (top)
4 Blower Wheel (bottom)
5 Cover, Left Side
6 EMI Filter
7 EMI Filter Bracket
8 Heat Slinger
9 Helper Spring, Interlock Switch*
10 Interlock Switch, Primary*
11 Mounting Bracket, Interlock Switch*
12 Power Cord
13 Voltage Sensor
* NOTE: For more interlock switch detail, see Figure A-11, page A-13.
Item Part Number Hardware Description
I5-9040 Nut, 1/4 - 20, Serr Hex Flange, Plated
I5-9042 Nut, 1/4 - 20, Serr Hex Flange, Plated
103551 None
103550 None
I5-9301 Screw, #8 Serr, PHD Truss, Black Oxide
100546 Screw, M5 x 8, PPHD, Sems, SS
I5-9257 Screw, #10-32 x 3/4 lg, PPH Sems, Int Th 102937 (qty 2)
102708 None
103599 None
102012 Screw, #4-40 x 1", PPH, Sems
I5-9272 Screw, #10-32 x 3/4 lg, PPH Sems, Int Th 102937 (qty 2)
I5-9127 None
100783 Screw, Sh Mtl #8 x 1/2, Serrated PHTRH 101688 (qty 1)
Hardware Part Number(s)
100906 (qty 4)
100906 (qty 4)
None
None
101691 (qty 5)
101707 (qty 4)
None
None
102903 (qty 2)
None
A-9