Removing Left Side Cover Required - TurboChef i3 Service Manual

A-8
APPENDIX - REPLACING OVEN COMPONENTS
Removing Left Side Cover Required (Figures A-7, A-8)
CAUTION: Before removing/installing any component, make sure it is disconnected from the
wire harness (where applicable).
CAUTION: Be careful to not tear the insulation when servicing components. Always reset the
insulation properly before reinstalling the side panel.
Hardware listed is required for installing component to oven.
To remove the left side cover, remove the screws securing the panel to the oven frame. To re-install the left
side cover, you may need to open the top cover (see page A-4 for details).
Figure
Item Description
Reference #
1 Blower Motor (top)
2 Blower Motor (bottom)
3 Blower Wheel (top)
4 Blower Wheel (bottom)
N/A Cover, Left Side
5 Heat Slinger
6 Helper Spring, Interlock Switch*
7 Interlock Switch, Primary*
8 Mounting Bracket, Interlock Switch*
N/A Power Cord
* NOTE: For more interlock switch detail, see Figure A-10, page A-11.
Item Part Number Hardware Description
i5-9220 Nut, 1/4 - 20, Serr Hex Flange, Plated
i5-9221 Nut, 1/4 - 20, Serr Hex Flange, Plated
104107 None
104108 None
i3-9301 Screw, #8 Serr, PHD Truss, Black Oxide
102708 None
i5-9397 None
102012 Screw, #4-40 x 1", PPH, Sems
i5-9272 Screw, #10-32 x 3/4 lg, PPH Sems, Int Th 102937 (qty 2)
i5-9127 None
Hardware Part Number(s)
100906 (qty 4)
100906 (qty 4)
None
None
101691 (qty 5)
None
None
102903 (qty 2)
None