Download Print this page
ViziT BK-100M Operating	 Instruction

ViziT BK-100M Operating Instruction

Commutator

Advertisement

Quick Links

Commutator
BK-100M
commutation device to provide intercom between the doorstation and apartment handsets UKP.
Commutator
BK-100M
Operating Instruction
The device does not contain voltage above
Do not perform any connections or repair, when the power is on!
For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM.
The list of companies is given on VIZIT.EU (
The device is fixed either with a springing clip to a DIN-rail (35 mm x 1-2 mm), or with screws (not supplied).
1
2
- Drill two holes
(1)
in a wall, with
diameter mm and depth
6
- Drive anchors
6х30
(2) into the holes
-
Fix the device by fastening 2 screws
in the anchors
.
Note. Fasteners are not supplied.
Figure1 - Mounting on a wall
www.vizit-group.com
OPERATING INSTRUCTION
(the device hereinafter) is intended for operation within
PARTS LIST
1
pc.
1
pc.
SAFETY INSTRUCTIONS
24 VDC
INSTALLATION
http://vizit.eu/eurounion/)
3
30
mm
.
.
3.5х
25
(3)
BK-100M Operating Instruction (revision
.
.
1
(1) - DIN-
(2) -
Holder for fixing on a DIN rail
Figure 2 - Mounting on a DIN-rail
VIZIT
apartment doorphones as a
2
rail, width
35
mm, depth
1-2
-
2015-
12
)
BK-
100M
mm
1 2
/

Advertisement

loading
Need help?

Need help?

Do you have a question about the BK-100M and is the answer not in the manual?

Questions and answers

Summary of Contents for ViziT BK-100M

  • Page 1 24 VDC Do not perform any connections or repair, when the power is on! INSTALLATION For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM. The list of companies is given on VIZIT.EU ( http://vizit.eu/eurounion/) The device is fixed either with a springing clip to a DIN-rail (35 mm x 1-2 mm), or with screws (not supplied).
  • Page 2 Ap. 53 Handset Commutator BK-100 LINE Figure 4 - Connection of apartment handsets to BK-100M The terminals LINE GND EK of your BK-100M device shall be connected to terminals of corresponding circuits either of the doorstation or control unit. Order of wiring...