Page 1
IR LED illumination for camera. Note. The doorstation supports only original RF identifiers from VIZIT - VIZIT-RF3.x and VIZIT-RF4.x ® Contents of multi-apartment doorphone and video doorphone VIZIT , its features and order of operation with the control...
Switch the power off before cleaning the product. Clean by wiping with dry soft cloth. Do not use any liquid cleaners, aerosol cleaners or abrasive agents. INSTALLATION For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM. The list of companies is given on VIZIT.EU ( http://vizit.eu/eurounion/) Before mounting and wiring, examine carefully the operating instruction for the installation order and wiring diagrams of the doorphone / video doorphone components.
Page 3
RX, TX Data exchange between doorstation and Control Unit Microphone +Е Supply voltage to doorstation SP+, SP- Speaker Ground to Control Unit Figure 5 Terminals layout www. vizit-group.com BVD 3 - 43 F(FCPL) Operating Instruction (revision 201 - 5 11)
Connect PRG wire to GND terminal of Control Unit when memorizing MASTER-key No1 Remember to disconnect PRG wire after MASTER-key No1 has been memorized. Figure 6 Doorstation -343 F(FCPL) with Control Unit BUD-302M (K-20, K-80) Electromagnetic Lock VIZIT-ML240-40 , and button EXIT 300 М Electromagnetic Button lock VIZIT-ML240-40...
SPECIAL FEATURES Application of RF keys VIZIT-RF3.x VIZIT-RF4.x (13.56 MHz provides enhanced security against unauthorized management of the access control system. For this purpose the doorstation has a PIN-code, which is recorded into RF keys memory during key binding, when keys are bound to a certain doorstation. If RF keys...
Page 6
To confirm, press the button. MASTER-key No 1 has been deleted. In one second the LED is displaying a blinking cursor The doorstation is on stand-by now www. vizit-group.com BVD 3 - 43 F(FCPL) Operating Instruction (revision 201 - 5 11)
Page 7
Switch the Control Unit off, and disconnect PRG wire from GND terminal. Memorize MASTER-key No2 and program the service personnel password as described earlier. www. vizit-group.com BVD 3 - 43 F(FCPL) Operating Instruction (revision 201 - 5 11)
VIZIT Firmware Update The application VIZIT Firmware Update is available for download on the connection unit CU-14 web page at the following Internet resources VIZIT: www.vizit-group.com, www. vizit.eu (see the section ‘Products’) Important After firmware update MASTER-keys, PIN-code and service personnel password memorized earlier in the doorstation do not change, they remain the same.
Need help?
Do you have a question about the BVD-343F and is the answer not in the manual?
Questions and answers