ViziT BKM 441 Operating Instructions

Commutator BKM -44
within VIZIT video doorphones.
v
Connection of calling devices to the apartment monitor
- the main entrance multi-apartment video doorstation (intercom and video)
- an individual doorstation on the storey (intercom and video)
- a DOOR BELL button at the apartment door
v
Option to connect an electromechanical lock or strike
v
Power supply unit 19w/14.4v/EU(18V/1.0A)
BPD 18/12-1-1 , BPD 24/12-1-1
v
All models within the following model lines of individual video doorphones
BVD -401, -403, -405, -406, -407, -410, -411
v
Commutators and distribution amplifiers part of multi-apartment video doorphones
BK -4М, -4MV ,-4 MVE, -4AV,
v
A DOOR BELL button - a button with normally open contacts
v
Colour video monitors
v
Electromechanical locks and trigger strikes, which have fail-locked with hold-open function. The lock/ strike is
unblocked after a short power impulse, and remains unblocked even when the power is off. The lock / strikes becomes
blocked again, after the door is opened and then closed again.
Note. Only monitors VIZIT
the full range of the Commutator's functions described in this operating instruction.
All monitors produced before April 2013, and monitors VIZIT-456C produced in 2013 will have limited functions
with the Commutator BKM-441 such as: selection of an individual ring tone for a DOOR BELL button is not
available. For the calls from the DOOR BELL button, the ring tone will be the same as selected for an individual
doorstation.
Commutator BKM -441
Operating instruction
The Commutator does not contain voltage above
Do not perform any connections or repair when the power is on.
For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM.
The list of companies is given on VIZIT.EU (
The Commutator shall be installed in heated premises with sufficient ventilation. The Commutator may be fixed either on
a wall, or on a DIN-rail.
1
2
- Drill 2 holes (1) in a wall, with 6 mm diameter and
- Drive anchors 6х30 (2) into the holes
- Fix the unit by fastening 2 screws
Note. Fasteners are not supplied.
Figure1 - Mounting on a wall
www.vizit-group.com
OPERATING INSTRUCTION
1 ( the Commutator hereinafter is intended to connect monitors
List of devices compatible with BKM-441
-
.
.
-10, -30М, -100М,
: VIZIT -М440С -М440СМ -М456С -М456СМ -МТ460СМ ,
-М440С -М440СМ -М456СМ -МТ460СМ , ,
,
SAFETY INSTRUCTIONS
24V
http://vizit.eu/eurounion/)
3
.
3.5х 25 (3) in the anchors
BKM-441 Operating Instruction (revision
)
FEATURES
:
regulated, 18V/1A. Other acceptable power supply units:
RVS -2, RVS , RVS-4M, -RVE-4 -4
, , ,
, of 2013
PARTS LIST
1 pc.
1 pc.
.
INSTALLATION
.
(1) - DI - N
30 mm depth.
(2) - Holder for fixing on a DIN rail
.
Figure 2 - Mounting on a DIN-rail
VIZIT to video and intercom lines
VIZIT :
VIZIT :
.
.
year of production and later will support
1
2
rail, width 35 mm, depth
-
2015- ) 11
BKM -44 1
1-2 mm
1/ 5