Advertisement
Quick Links
INSTRUCTIONS - CINEMASNAP 235
MASNAP 235
CINEMASNAP 235
Thank you for purchasing a Screen Technics Projection Screen, please
ensure that you read the following instructions fully before attempting to
install this product.
IMPORTANT INSTRUCTIONS
This product has been finished in black flocke velvet and as such is easily damaged during the
installation process. It is recommended that you layout all the parts and construct the unit on a soft
clean surface, such as a drop sheet, so as not to damage the frame finish.
FRAME ASSEMBLY
STEP 1.
Layout all components ready for assembly as shown above.
STEP 2.
Assemble the bottom and two side frames
together, please note the larger head- box top frame
should be put aside during this process
AUSTRALIA
22-24 Suttor Road, Moss Vale NSW 2577
+61 2 4869 2100
STEP 3.
Push the two corners of the frame together. You may need to use a plastic or wooden
mallet (not metal) to achieve this result, please use mallet very softly so not to damage finish,
although a good wiggle of the frame will normally suffice.
STEP 4.
With the Hex Head Allen-Key bolt use the
provided Allen-Key to screw tight both corners. You
must ensure both corners are square and that no
visible gaps are obvious before you start to insert the
bolt, otherwise jamming may occur.
STEP 5.
Before fully tightening the external Allen-Key
bolts, tighten the internal frame Allen- Key bolts, one in
each corner, then finally fully tighten the external bolts.
STEP 6.
You will see connected to the bottom corner of the side frames an angle bracket that
now requires bolting to the bottom frame using the M5 nut and bolts provided. The lower half of
your frame in now complete, now to assemble the top section.
STEP 7.
With the three piece frame assembly lying on its
back, carefully position the Head- box unit into place at
the top of the frame. Do not remove the brown paper
that holds the masking in place, but remove or tear
small sections of the paper if in the way of assembly
NEW ZEALAND
44 Mahana Road, Te Rapa, Hamilton
+0800 022 821
Continued Over.../
info@screentechnics.com.au
screentechnics.com.au
1
Advertisement
Related Manuals for Screen Technics CINEMASNAP 235
Summary of Contents for Screen Technics CINEMASNAP 235
- Page 1 Thank you for purchasing a Screen Technics Projection Screen, please STEP 3. Push the two corners of the frame together. You may need to use a plastic or wooden ...
- Page 2 INSTRUCTIONS - CINEMASNAP 235 STEP 8. Push the two corners together. You may need to use a plastic or wooden mallet (not STEP 5. Once you have determined the best location for metal) to achieve this result, although a good wiggle will normally suffice.
- Page 3 The motor limits for the masking have been set at the factory and should not be adjusted without prior authority from Screen Technics, as serious damage may result, voiding any warranty regards this product. ...
- Page 4 • FOR INFRA RED OPERATION YOU WILL REQUIRE • (SUPPLIED SEPARATELY) • • Screen Technics 2 Channel infra red • Infra Red Receiver transmitter (Product Code 6500101) IR Receiver • Screen Technics Connect infra red sensor Input ...
- Page 5 • • Contact close can be reprogrammed to single latched mode by using the 6 button infra red transmitter if required. (Contact Screen Technics for details) • • Two button impulse switches are available (Product Code 3500998) ...