Make A Call With A Standard Headset; Audio Path Selection; Swap Headsets While On A Call - Cisco Headset 500 Series Manual

Headsets
Step 2
Navigate Admin settings > Aux port.
Step 3 Select Connect e-hook headset to enable electronic hookswitch control.

Make a Call with a Standard Headset

Use your headset for hands-free calling that won't disturb your coworker and gives you some privacy.
Procedure
Step 1 Plug in a headset.
Step 2
Enter a number using the keypad.
Step 3 Press Headset

Audio Path Selection

When you make or receive a call, the audio path goes to the last device used by you, either the handset, the
headset, or the speakerphone. The following list describes each scenario:
• Pick up the handset when you make or answer a call, and all of your calls are routed to your handset until
• Select Headset
• Select Speakerphone

Swap Headsets While on a Call

When you connect multiple headsets to the phone, you can switch among the headsets during a call by pressing
the Headset key on the phone. Though the phone is connected to multiple devices, you see a specific headset
is selected as the preferred audio device in the following priority order:
• When you connect only an analog headset to the phone, you make your analog headset the preferred
.
you select Headset or Speakerphone
when you make or answer a call, and all of your calls are routed to your headset
until you pick up the handset or select Speakerphone
If your administrator sets your headset as the audio path on your phone, then you can remove the handset
and use your headset. This is ideal for anyone who prefers the convenience of a headset. But you must
still select Headset the first time you handle a call.
speakerphone until you pick up the handset or select Headset
audio device.
.
when you make or answer a call, and all of your calls are routed to your
Make a Call with a Standard Headset
.
.
Headsets
35