Cisco Headset 500 Series Manual page 10

Cisco Headset 560 Series Multibase
Number
2
Cisco Headset 560 Series Multibase
The multibase can connect up to three call sources through Bluetooth, the USB connector, or the Y-cable.
The multibase can save up to four Bluetooth devices. You can switch between call sources using the buttons
on the multibase. You use the call control buttons on the headset to answer and end calls. When your headset
is in the base, you automatically answer the call when you remove the headset from the base. You can return
the headset to the base to end the call.
The multibase comes with the following connector cables:
• USB to USB Cable: for Cisco IP Phones with USB connectivity
• USB Y-Cable: for Cisco IP Phones without a USB port
• Mini USB Cable: for PC or Mac.
• Mini USB to USB-C Cable: available separately for PC or Mac devices.
Figure 11: Multibase LEDs
The following table describes the Cisco Headset 560 Series Multibase multibase LEDs.
Headsets
10
Name
Call Status LED
Description
Alerts you to the call state:
• Incoming call—Blinking green
• Active call—Steady green
• Muted call—Steady red
Headsets