Cisco Headset 500 Series Manual page 9

Headsets
Cisco Headset 560 Series Standard Base
The standard base charges your headset and has LEDs that shows your headset's battery level and call state.
You can also answer and end calls when you lift or place your headset on the base.
The standard base comes with the following connector cables:
• USB to USB Cable: for devices with USB connectivity
• USB Y-Cable: for Cisco IP Phones without a USB port
• USB-A to USB-C Cable: available separately for PC or Mac devices.
Figure 10: Standard Base LEDs
The following table describes the standard base.
Table 5: Standard Base LEDs
Number
1
Name
Battery Status LED
Cisco Headset 560 Series Standard Base
Description
Indicates the headset battery charge and base status:
• Headset battery strength—LEDs blink and change to
solid as the battery charges.
• Headset update in progress—LEDs blink in sequence,
left to right.
• Headset and base not paired—All LEDs blink
• Power save mode—Middle LED shows solid.
The base enters power save mode when there is no call source
connectivity after 10 minutes.
Headsets
9