Eaton Linear TechBench partial shelf Installation Sheet

Installation sheet
Linear TechBench
shelf installation

TOOLS REQUIRED

(1) Phillips screwdriver (not supplied)
(1) Plastic mallet (not supplied)
Tools required
TOOLS REQUIRED
(1) Phillips screwdriver (not supplied)
(1) Phillips screwdriver (not supplied)
(1) Plastic mallet (not supplied)
(1) Plastic mallet (not supplied)
1. Determine the location for the Partial Shelf and attach
1. Determine the location for the Partial Shelf and attach
1. Determine the location for the partial shelf and attach the
the Brackets to the TechBench™ as shown in figure 1.
the Brackets to the TechBench™ as shown in figure 1.
NOTE: Be sure that the Brackets are at the same
brackets to the TechBench™ as shown in figure 1.
NOTE: Be sure that the Brackets are at the same
level.
NOTE: Be sure that the Brackets are at the same level
Tap the top of each Bracket with a plastic mallet to
Tap the top of each Bracket with a plastic mallet to
ensure that the hooks are fully seated.
Tap the top of each Bracket with a plastic mallet to ensure
ensure that the hooks are fully seated.
that the hooks are fully seated.
2. Lock each Bracket in place using two #10-24 x 3/8"
2. Lock each Bracket in place using two #10-24 x 3/8" pancake
2. Lock each Bracket in place using two #10-24 x 3/8"
pancake phillips head screws (provided). See figure 2.
pancake phillips head screws (provided). See figure 2.
phillips head screws (provided). See figure 2.
91648
L i n e a r
P a r t i a l
I n s t a l l a t i o n
L i n e a r
P a r t i a l
I n s t a l l a t i o n
level.

Figure 1

Figure 1
Figure 1
Rev. __ Date:
T e c h B e n c h ™
partial
™
S h e l f
T e c h B e n c h ™
S h e l f
Linear TechBench partial shelf
Linear TechBench™ Partial Shelf
Linear TechBench™ Partial Shelf
Hooks
Hooks
Right hand bracket
Right Hand Bracket
Hooks
Right Hand Bracket
#10-24 x 3/8" phillips
#10-24 x 3/8" phillips
head screws
head screws
#10-24 x 3/8" phillips
head screws
1
Slots
Slots
Slots

Figure 2

Figure 2