Table of Contents
Advertisement
6. Data logging
6.1
Preparation
a. Insert SD memory card:
Insert the SD memory card into the card holder. Please consider inserting in the right
direction. Avoid pushing with too much pressure. The SD memory card should latch in
without applying much force.
b. Formatting the SD memory card:
If you use the SD memory card for the first time, the SD memory card must be formatted first.
You can read the relevant instructions under chapter 8.8
c. Set time:
If you use the device for the first time the time will be not set yet. The relevant instructions
can be found under chapter 8.1
d. Set decimal point:
The decimal point will be set by the manufacturer, e.g. "20.6" or "10000.43". In some
languages, for example in Germany, there is a comma for the decimal digits, e.g. "20,6" or
"10000,43". If you prefer the format with a comma, please follow the instructions under
chapter 8.3.
6.2
Automatic data logging function
a. Start data logger:
Press the "REC" button once, so the display will show the "REC" symbol. Press "Logger"
button afterwards, so that the "REC" symbol starts blinking and the device starts saving the
measured data on its SD card.
b. Pause data logger:
The data logger can be also paused during recording, by pressing the "Logger" button. The
"REC" symbol will then stop blinking.
c. Shut down data logger:
To shut down the data logging function during operation, press the "REC" button. Therefore
press the "REC" button for 2 seconds. The "REC" symbol will then disappear from display.
6.3
Manual Data logger function
a. Set the logging interval to 0 seconds:
Press the "REC" button once, so the display will indicate "REC". Press then the "Logger"
button, so that the "REC" symbol starts blinking and a beeper goes off. The measured data
will be then recorded simultaneously on the SD memory card. The storage space number of
the relevant data set will be indicated at the bottom line of the display.
Note: In the mode for manual data logging you can select the storage space 1 to 99 (e.g. room 1 to
room 99) with the ▼-button or the ▲-button. The relevant space will indicated on the display with Px
(with x = 1 to 99). After selecting the storage space, you can confirm the selection by pressing "REC".
Thus the device will start logging the values.
b. Shut down Data logger function:
To exit the function press the "REC" button for 2 seconds. The "REC" symbol will
then disappear from the display
6.4
Information on time
During the standard measurement mode (without data logger function) you can check the recorded time
and date by pressing the "time check" button. The display will then show the set date and time.
Address:East Room 306,3th Floor,1st Building,Shenhua Industrial Park,Meihua Road, Futian District,Shenzhen City
Manual
Tel:0755-32978297
7
Email:hj@pce-instruments.cn
Advertisement
Table of Contents
