Table of Contents
Advertisement
How to test an WR44V2 step by step.
4 PERFORM LOW LEVEL TESTS
Connect the serial port of the PC to the WR44V2 using the serial cable.
From the Windows command line run the mvtest program including as an argument the PC com port
number:
mvtest -p 1
(E.g. for COM port 1)
mvtest -p 2
(E.g. for COM port 2)
Then power up the WR44V2. This may take a little practise. (Note that with the WR44V2 there is no
need to hold in the reset button for this step.)
Check the output of the mvtest program. If the test passes then the following output will be seen:
If all test show "passed" the router can now be safely power cycled.
If the SDRAM or FLASH test shows "failed" then the product should be returned via RMA. When
requesting the RMA please include the appropriate fail reason:
mvtest fail: SDRAM
mvtest fail: FLASH
Page | 7
Advertisement
Table of Contents
Need help?
Do you have a question about the TransPort WR44 v2 and is the answer not in the manual?
Questions and answers