Next Steps - NetApp AltaVault Cloud Integrated Storage 4.1 Installation And Service Manual

Next steps

2. Obtain the Service Processor IP configuration and firmware version:
SP> sp status
Firmware Version:
Debug Mode: Enabled
Mgmt MAC Address:
Ethernet Link:
Using DHCP:
IPv4 configuration:
IP Address:
Netmask:
Gateway:
IPv6 configuration: Disabled
3. Enter the following IPMI command to test the Service Processor feature:
SP> system sensors
Sample output (truncated):

Next steps

After you log in to AltaVault appliance, the configuration wizard displays and allows you to choose from the following:
Specify system settings, including time zone and DNS.

Configure cloud settings, including cloud credentials, licenses, and data encryption.

Configure data interfaces that are used to receive data from the backup application.

Configure CIFS shares or NFS exports that the backup application can access.

Optionally, configure peer monitoring, email alerts, SNMP, and additional login security.

Export the Virtual AltaVault configuration for safe keeping in the event of a disaster.

To manage Virtual AltaVault using the command-line interface, see the NetApp AltaVault Cloud Integrated

Storage Command-Line Interface Reference Guide.
NetApp AltaVault Cloud Integrated Storage Installation and Service Guide for Physical Appliances
3.0.2
00:A0:98:65:03:24
Up, 1000Mb, Full-Duplex, Auto-neg enabled,completed
no
172.16.33.154
255.255.240.0
172.16.33.1
Deploying AltaVault
37