Advertisement
Available languages
Available languages
1. Remove Taillights – Open trunk. Remove access panel from behind
taillight. Using a 10mm socket, remove (2) hex nuts that secure taillight.
Unplug the electrical connector and push wiring with rubber grommet
through hole in body. Remove the taillight by gently pulling horizontally
rearward. Repeat on other side of vehicle.
Note: During taillight removal, filler panel on side of light assembly
may detach from taillight. Ensure panel is reinstalled before taillights
are reinstalled on vehicle.
Filler Panel
HYUNDAI MODELS
3. Lower Exhaust – Using an exhaust hanger removal tool (or pry bar)
remove the rubber isolators from hangers.
Note:
Support the exhaust before lowering.
HYUNDAI MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
Electrical
Nuts
Plug
2. Remove Underbody Panel – Using a 10mm socket and flat head
screwdriver, remove (4) hex nuts and (3) push pin rivets from underbody
panel on the driver's side of vehicle.
Nuts
Push Pins
HYUNDAI MODELS
Note:
Removal of the heat shield is not required but can be removed to assist
with modification. Cut or bend the area around the rearmost stud to make
clearance for the hitch. Make sure to leave the hole in the heat shield so that it
may be reattached. If removed modify and reattach. (See Figure 5)
Trim
HYUNDAI MODELS
Sheet 9 of 60
24964NP
06-24-19
Rev. C
Advertisement
