Advertisement
Available languages
Available languages
10. Install Fascia and Bumper Assembly – Using alignment pins in bumper as a guide,
reinstall fascia and bumper assembly onto vehicle. Hand tighten bolts to hold
bumper and hitch in place. Align and re-engage all clips. Reinstall all screws and
push pin rivets removed from fascia.
a)
USA built models: Secure hitch to vehicle using supplied M10 bolts,
o
item
(2) per side and 7/16" conical washers, item
toward hitch).
b)
Korean built models: Secure hitch to vehicle using supplied M8 bolts,
p
item
(2) per side and 3/8" conical washers, item
toward hitch).
Note:
Use second person or jack to steady hitch while lifting into position
and hold until all bolts are installed.
Alignment Pin
HYUNDAI MODELS
12. Install Cable Ties – Insert cable ties through holes in underside of
fascia previously used by support brackets, wrap cable ties around
hitch tube. Tighten cable ties and trim excess.
Insert Cable Ties
HYUNDAI MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
11. Torque Fasteners – Tighten all M8 fasteners to 27 Lb-Ft. (37
N*M), all M10 fasteners to 42 Lb.-Ft. (57 N*M), and all 7/16
fasteners to 50 Lb.-Ft. (68 N*M).
l
Proper torque is needed to keep the hitch secure to the vehicle
(teeth side
when towing.
q
(teeth side
13. Raise Exhaust – Raise exhaust into position by reattaching the
rubber isolators to the hangers.
HYUNDAI MODELS
HYUNDAI MODELS
Sheet 13 of 60
24964NP
06-24-19
Rev. C
Advertisement
