Horizon Fitness 24964 Installation Instructions Manual page 6

Note: Removal of the heat shield is not required but can be removed to assist
with modification. Cut or bend the area around the rearmost stud to make
clearance for the hitch. Make sure to leave the hole in the heat shield so that it
may be reattached. If removed modify and reattach. (See Figure 5)
Trim
HYUNDAI MODELS
j
5. Fish Wire – Attach items and
n
in Figure 2. Leave item attached until the hitch is raised into position.
Note: If plastic caps are covering the access hole remove and return
to owner.
HYUNDAI MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
k n
to item and follow the instructions
4. Remove Existing Hardware – Remove the existing 10mm bolts (2)
each side from the bulk head.
HYUNDAI MODELS
6. Install Hitch – Raise hitch into position, be careful not to push the
hardware into the frame.
a) USA built models: Secure hitch to vehicle using supplied 10mm
o
bolts, item (2) per side and 7/16" conical washers, item
(teeth side toward hitch).
b) Korean built models: Secure hitch to vehicle using supplied
p
8mm bolts, item (2) per side and 3/8" conical washers, item
q
(teeth side toward hitch). Attach the hitch to the bulk head.
n
Then remove item
HYUNDAI MODELS
Sheet 6 of 60
l m j
and attach item and to item
24964NP 06-24-19
l
.
Rev. C