Advertisement
Available languages
Available languages
6. Trim Fascia – On underside of fascia, measure between outer
support bracket holes to find center of fascia. Mark center of fascia.
Mark 3" wide section centered on the center line of fascia. Mark 5"
long section perpendicular to edge of fascia. Trim marked section
from fascia to give clearance for the receiver tube of the hitch (See
Figure 3).
Note:
Do not use middle support bracket hole for
measurement, hole is not centered in fascia.
Center of fascia
HYUNDAI MODELS
j
8. Fish Wire – Attach items
hole in vehicle frame, follow the instructions in Figure 2. Leave item
n
attached until the hitch is raised into position.
Note:
If plastic caps are covering the access holes, remove and
return to vehicle owner.
HYUNDAI MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
5"
3"
k
n
and
to item
and insert in access
7. Reassemble Fascia – Reinstall center section of fascia and signal
lights removed in Step 5.
HYUNDAI MODELS
9. Install Hitch – Raise hitch into position, be careful not to push the
hardware into the frame. Remove item
m
hand tighten item
to item
Note:
Conical washer can be used to hold bolt in place while
removing fish wire and installing hex nut.
Note:
Use second person or jack to steady hitch while lifting
into position and hold until all bolts are installed.
HYUNDAI MODELS
Sheet 12 of 60
n
l
and attach item
j
.
24964NP
06-24-19
and
Rev. C
Advertisement
