Horizon Fitness 24964 Installation Instructions Manual page 17

1. Remove Underbody Panel – Using a 10mm socket and flat head
screwdriver, remove (4) hex nuts and (3) push pin rivets from underbody
panel on drivers side of vehicle.
Nuts
Push Pins
KIA MODELS
3. (A). Remove Fascia and Bumper Beam Assembly – Remove (1)
push pin rivet and (1) phillips head screw from fascia under
taillight area, both sides.
Screw
KIA MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
2. Remove Taillights – Open liftgate. Remove small access panel from behind
taillights. Using a 10mm socket, remove (4) hex nuts that secure taillights,
both sides. Unplug the wiring and remove the taillights by gently pulling
rearward.
3. (B). Remove Fascia and Bumper Beam Assembly – Using a phillips
head screw driver, remove (3) screws from wheel well liner and
fascia, both sides.
Push pin
Nuts
Electrical
KIA MODELS
KIA MODELS
Sheet 17 of 60 24964NP
Screws
06-24-19 Rev. C