Horizon Fitness 24964 Installation Instructions Manual page 20

9. Trim Lower Fascia – Using a tape measure, marker, and utility knife, cut a 5" wide
X 3" deep notch in the bottom center of fascia. See Figure 3. Using a utility knife,
carefully remove the (2) raised areas, used to connect plastic support brackets,
flush to inside surface of lower fascia. See Figure 4.
10. Reinstall Lower Fascia – Reinstall lower fascia aligning tabs in lower fascia with
upper fascia and snap into place.
CUT
3"
5"
KIA MODELS
12. Install Cable Ties – Measure 13" from center of vehicle and 2-1/4"
from forward edge of lower fascia and drill a ¼" hole through
fascia. Install cable tie (item 10) through hole, around hitch
crosstube, and tighten cable tie. Trim excess length from cable tie.
Both sides. See Figure 3.
KIA MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
13"
2 ¼"
11. Reinstall Taillights and Wiring – Using the original hardware, reinstall
taillights and reconnect wiring. Reinstall small access panels.
KIA MODELS
13. Reinstall Underbody Panel – Using original fasteners removed in
step 1.
KIA MODELS
Sheet 20 of 60 24964NP 06-24-19 Rev. C