Horizon Fitness 24964 Installation Instructions Manual page 10

4. (A). Remove Fascia and Bumper Beam Assembly – Under taillight:
Remove (2) push pin rivets and (1) phillips head screw from fascia
under taillight area. Repeat on other side of vehicle.
Push Pins
HYUNDAI MODELS
4. (C). Underside of Fascia – Using a flat head screw driver, remove (3)
push pin rivets from bottom edge of fascia. (2) located by
passenger side rear tire, (1) located by driver side rear tire.
Pushpins
HYUNDAI MODELS
©2017, 2018, 2019 Horizon Global™ Corp. – Printed in Mexico
Screw
4. (B). Fender Wells – Using a phillips head screw driver, remove (3)
screws and one 8mm hex head screw from wheel well liner and
fascia. Repeat on other side of vehicle.
HYUNDAI MODELS
4. (D). Bumper Fasteners – Using a 12mm socket, remove (2) bolts
holding bumper beam to end panel. Repeat on other side of
vehicle. Return bolts to vehicle owner.
HYUNDAI MODELS
Sheet 10 of 60
Screws
24964NP 06-24-19 Rev. C