Input/Output (I/O) Addresses - Creative Structures Sound Blaster 16 Getting Started

If your card encounters a conflict with a peripheral device, you
may need to change its resource settings. If you are using
Windows 95, run the Device Manager. If you are using
Windows 3.1x, run the configuration utility that comes with
your PnP configuration manager. For details, see "Resolving
Hardware Conflicts" on page C-5. When any resource setting
is changed, ensure that the environment variables (see
"Understanding the Environment Variables" on page A-3)
reflect the changes as well. You can view your system
environment by typing SET at the DOS prompt.

Input/Output (I/O) Addresses

I/O addresses are communication areas used by your computer's
central processor to distinguish among various peripheral devices
connected to your system when sending or receiving data.
Table A-1: Possible default I/O addresses used by the various devices on the audio card.
I/O Address Range
100H
1E8H to 1EFH
168H to 16FH
200H to 207H
220H to 22FH
330H to 331H
388H to 38BH
620H to 623H,
A20H to A23H,
E20H to E23H
Refer to "General Specifications" of the Knowing Your Audio
Card leaflet to find out which devices marked
your card.
A-2 Understanding the Installation
This manual downloaded from http://www.manualowl.com
Device
§
3D Stereo Enhancement device
§
IDE interface (Tertiary)
§
IDE interface (Quarternary)
Game/Joystick interface
Audio interface
MPU-401 UART MIDI interface
Stereo music synthesizer
§
Advanced WavEffects synthesizer
(Advanced Wavetable synthesizer)
§
are available on