Bogen NYQUIST NQ-S1810WT-G2 Installation Manual page 6

Speaker Installation
Step 5
Use Category 5 or higher Ethernet
cable to connect the speaker
(Figure 8). The power is supplied
by PoE using an 802.3af compliant
network switch or PoE injector
Step 6
To assemble the Wall Baffle Speaker (Figure 9), first align the two notches
(A) located at the top of the speaker baffle with the notches (B) at the
top of the rear housing. Then, rotate the speaker baffle downward until
the two bottom sections (C & D) snap together.
NOTE: Refer to the Nyquist Gen-
2 VoIP Speakers Configuration
Manual or the Nyquist System
Administrator Manual for de-
tailed instructions on how to
configure these speakers.
Using the Reset Button
The Reset button (Figure 10) allows you to either reboot the VoIP speak-
er or to reset the appliance's configuration settings to the factory default
settings. For more information about resetting configuration settings,
refer to the Nyquist Gen-2 VoIP Speakers Configuration Manual.
(cont'd)
.
Figure 8
Figure 9
Figure 10