Align-Pilates Ladder Barrel Mk II Assembly Instructions Manual
  1. Manuals
  2. Brands
  3. Align-Pilates Manuals
  4. Fitness Equipment
  5. Ladder Barrel Mk II
  6. Assembly instructions manual

Align-Pilates Ladder Barrel Mk II Assembly Instructions Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Thank you for purchasing an Align-Pilates Ladder barrel, we trust that this will prove to be a valued
addition to your Pilates Studio. We have strived to make our ladder barrel as flexible as possible,
designing the barrel to open widely and close tightly which combined with the inclusion of two
padded standing platforms for free, making the apparatus suitable for people of all shapes and
sizes.
Content

1. Unpacking the Ladder Barrel

2.

7. Exploded diagram

1. Unpacking the ladder barrel
Please note these assembly instructions are not exhaustive. At all times you are responsible for your own
safety.
Please unpack the equipment in a clear, clean & dry environment on a level floor surface.
Remove all strapping using a safety knife and remove the carton lid carefully
Ladder Barrel Mk II Assembly Instructions
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ladder Barrel Mk II and is the answer not in the manual?

Questions and answers

Related Manuals for Align-Pilates Ladder Barrel Mk II

Summary of Contents for Align-Pilates Ladder Barrel Mk II

  • Page 1 Ladder Barrel Mk II Assembly Instructions Thank you for purchasing an Align-Pilates Ladder barrel, we trust that this will prove to be a valued addition to your Pilates Studio. We have strived to make our ladder barrel as flexible as possible,...
  • Page 2 2. Ladder Barrel Schema 3. Tools and Components Diagram...
  • Page 3 4. Assembly Instructions  Take out the side panels and lay on a soft surface so as not to scratch the wood. Attach the side panels to the barrel top using x 3 medium bolts with Loctite washers and nut, ensure a washer is used on each side - the nut goes on the inside of the barrel (Fig.
  • Page 4 Fig. 4 Fig. 5  Now insert the x4 short rungs into the uprights and using the x 8 short bolts with flat washers and tighten (Fig. 6). As before start by inserting all the poles and loosely tightening and then once all the poles are in place tighten them all in turn.
  • Page 5  Now slide the barrel top and sides onto the frame Fig. 9 Fig. 9  Attach the barrel top and sides into the frame using the x4 hand screws as in Fig.10. It is important that the silicon pad on the washer is in contact with the runner (Fig. 11). Fig.
  • Page 6 Use a spirit level and fine tune with the adjustable feet until flat in both planes. The equipment is only suitable for indoor use on a level floor. Congratulations! You have now completed the assembly of your Align-Pilates Ladder Barrel. Before first use please read the below information on proper use and safety.
  • Page 7 Upholstery The upholstery fabric on Align-Pilates equipment will be replaced if it fails to give normal wear for 90 days from the date of delivery. Proof of damage may be required. This warranty does not cover cuts, scratches, burns, stains, soiling, or damages caused by unreasonable use such as wearing jewellery or inappropriate clothing whilst using the equipment.

Table of Contents