output:impedance 0
pulse:width 1 us
pulse:delay 2 us
volt 200
output on
These commands will satisfy 90% of your programming needs.
ALL PROGRAMMING COMMANDS
For more advanced programmers, a complete list of the available commands is given
below. These commands are described in detail in the "Programming Manual for -B
Instruments". (Note: this manual also includes some commands that are not
implemented in this instrument. They can be ignored.)
Keyword
OUTPut:
:LOAD
:[STATe]
:IMPedance
:PROTection
:TRIPped?
[SOURce]:
:FREQuency
[:CW | FIXed]
[SOURce]:
:PULSe
:PERiod
:WIDTh
:DCYCle
:HOLD
:DELay
:GATE
:TYPE
:LEVel
[SOURce]:
:VOLTage
[:LEVel]
[:IMMediate]
[:AMPLitude]
:PROTection
:TRIPped?
STATUS:
:OPERation
:[EVENt]?
:CONDition?
:ENABle
:QUEStionable
:[EVENt]?
:CONDition?
(sets the output impedance to 0Ω. The only other allowed
setting is output:impedance 50.)
(sets the pulse width to 1 us)
(sets the delay to 2 us)
(sets the amplitude to 200 V)
(turns on the output)
Parameter
<numeric value>
<boolean value>
<numeric value>
<numeric value>
<numeric value>
<numeric value> | EXTernal
<numeric value>
WIDTh | DCYCle
<numeric value>
ASYNC | SYNC
HIgh | LOw
<numeric value> | EXTernal
<numeric value>
Notes
[query only]
[query only]
[query only, always returns "0"]
[query only, always returns "0"]
[implemented but not useful]
[query only, always returns "0"]
[query only, always returns "0"]
30
Need help?
Do you have a question about the AVR-8F-B-P-ADB1A and is the answer not in the manual?