Table of Contents
Advertisement
3.2
Main Panel
The Main panel of the AG 5800 web interface is used to configure the unit to decode,
de-encapsulate and demodulate. When configuring the AG 5800 the user begins at
the top of the menu and works down. The inputs are configured, then descrambling (if
present), then service or PIDs are selected for decode, then outputs are configured.
Figure 8 below is a card equipped with the DVB-S/S2 input option, CAM module, and
all applicable options licensed.
3.2.1
Configuring Active Inputs
This menu allows the user to configure a primary and backup input. In case there
is an input failover the AG 5800 is capable of detecting the failed state and switching
to a secondary backup input in order to provide a continuous output. Which input is
primary and backup, how the inputs switchover and restore and switchover timing
Page 23 (107)
AG 5800 – User Manual
Figure 8: Main Panel
Advertisement
Table of Contents
