Table of Contents
Advertisement
Setting the Control Panel
Settings for the control panel
Panel brightness and saver time can be set for each of the Control Panel.
Buzzer settings
Set when the buzzer sound on the menu panel is enabled or disabled.
1
Select the <PANEL> button → [OTHER SETTINGS] → [Panel1]/[Panel2]/[Panel3] tab.
2
Select an item in [Touch Sound]/[Register Sound]/[Error Sound] in the [Touch Sound] column.
[Touch Sound]
[Register Sound]
[Error Sound]
Setting menu delegation
For details on the menu delegation function, refer to "Menu delegation function".
Setting the saver time
The panel backlight can be automatically turned off when panel operation becomes idle for a certain period.
f This setting is applied to Menu Panel, multi-selection panel, and source name display panel.
1
Select the <PANEL> button → [OTHER SETTINGS] → [Panel1]/[Panel2]/[Panel3] tab.
2
Select an item in [Saver Time] in the [Saver Time] column.
[On]
[Off]
[60], [120], [180]
NOTE
@
t The backlight does not turn on even if a mouse is used.
Setting the panel brightness
1
Select the <PANEL> button → [OTHER SETTINGS] → [Panel1]/[Panel2]/[Panel3] tab.
2
Set [MenuPanel] in the [Brightness] column.
f Adjust the brightness of the Menu Panel.
3
Set [Select Panel] in the [Brightness] column.
f Adjust the brightness of the multi-selection menu panel.
4
Set [Source Name] in the [Brightness] column.
f Adjust the brightness of the source name display panel.
Setting the button color
The lighting color for each of the Control Panel buttons can be set.
Setting the colors when the buttons are turned on
f You can select [Red], [Green], [Yellow], [Orange], and [ColorGroup1] to [ColorGroup8].
1
Select the <PANEL> button → [BUTTON COLOR] → [Settings] tab.
2
Select an item in [High Tally] in the [Select Button] column.
f Set the color of the button included in the on-air output.
f Applicable buttons are the AUX bus crosspoint buttons, KEY bus crosspoint buttons, PGM/A bus crosspoint buttons, PST/B bus crosspoint buttons,
corresponding buttons from <KEY1 TRNS>, <KEY2 TRNS>, <KEY3 TRNS>, <KEY4 TRNS> and buttons from <DSK1 TRNS>, <DSK2 TRNS>.
3
Select an item in [Low Tally] in the [Select Button] column.
f Set the color of the button not included in the on-air output (except Preset).
f Besides the AUX bus crosspoint buttons, KEY bus crosspoint buttons, the PGM/A bus crosspoint buttons, and the PST/B bus crosspoint buttons,
other buttons excluding Preset are also included.
4
Select an item in [Preset (XPT)] in the [Select Button] column.
f Set the color of the crosspoint button Preset button.
Chapter 8 System Menu — Setting the Control Panel
Sets the enable ([ON])/disable ([OFF]) of the buzzer sound during the touch screen operation in the menu panel.
Sets the enable ([ON])/disable ([OFF]) of the buzzer sound during the [Store] operation of the memory.
Sets the enable ([ON])/disable ([OFF]) of the buzzer sound when the error message is displayed.
Backlight is turned on all the time.
The backlight turns off as soon as [Off] is set. It turns on again when the panel is operated. The setting after it turns on
becomes [On].
When no control panel operation is performed within a set time interval (60, 120, or 180 minutes), the built-in display
backlight is turned off automatically. It turns on again when the panel is operated.
– 128 –
Advertisement
Table of Contents
