Control Panel Av-Hs60C4 - Panasonic Live Production Suite Series Operating Manual

Control Panel AV-HS60C4

Power supply
AC 100 V to 240 V, 50 Hz/60 Hz
Power consumption
40 W
Supports redundant power supply.
indicates safety information.
Control terminal
<MAIN FRAME> terminal
<MENU PANEL> terminal
<DVI-D> terminal
<USB> terminal
Display selector switch
<COM1 (M)> terminal
<COM2 (RS-232)> terminal
<GPI I/O> terminal
ME number
Other
Ambient operating temperature
Humidity
Dimensions (W×H×D)
Mass
r For AV-HS60C4E
Inrush current, measured according to European standard EN55103-1, on initial switch-on: 3 A, after a supply interruption of 5 s: 25 A (Each mains
input)
Chapter 10 Specifications — Specifications
Compatible with 100Base-TX and AUTO-MDIX
f Connection cable: LAN cable (CAT5E), straight cable, STP (Shielded Twisted Pair), 10 m (32.8 ft)
f Connector: RJ-45
* When connected to the <LAN> terminal, no video will be displayed on the Menu Panel AV-HS60C3.
Used only for the Menu Panel AV-HS60C3
f Connector: DVI-D
f Because an independent signal format is used, cannot be displayed on a DVI-D monitor.
f Cannot be used concurrently with a DVI-D monitor (computer) connected to the <DVI-D> terminal. Select with the
display selector switch.
Used for displaying menus to the DVI monitor (computer)
f Connector: DVI-D
f Monitor resolution: 1366×768 compatible monitor
f Cannot be used concurrently with the <MENU PANEL> terminal. Select with the display selector switch.
This terminal cannot be used with the Live Production Suite series. Do not connect anything to this terminal.
For DVI monitor (computer) menu operation
f Connector: USB (Type A, female)
f Cannot be used for the Menu Panel AV-HS60C3.
This terminal cannot be used with the Live Production Suite series. Do not connect anything to this terminal.
Switch for selecting <MENU PANEL> terminal or <DVI-D> terminal
This switch cannot be used with the Live Production Suite series. Fix this to the <MENU PANEL> side for use.
RS-422 control terminal
For master connection for controlling external devices
f Connector: D-sub 9-pin (female), inch screw
This terminal cannot be used with the Live Production Suite series. Do not connect anything to this terminal.
RS-232 control terminal
For external device control connections
f Connector: D-sub 9-pin (male), inch screw
This terminal cannot be used with the Live Production Suite series. Do not connect anything to this terminal.
GPI IN: 8 inputs, general-purpose, photocoupler sensing
ALARM OUT: 1 output, open collector output (negative logic)
GPI OUT: 10 outputs, selected from general purpose, tally
Open collector output
f Connector: D-sub 25-pin (female), inch screw
f Logic is switchable by menu.
This terminal cannot be used with the Live Production Suite series. Do not connect anything to this terminal.
2ME
0 °C to 40 °C (32 °F to 104 °F)
10% to 90% (no condensation)
656 mm×160 mm×400 mm (25-27/32 inches×6-5/16 inches×15-3/4 inches) (excluding protrusions)
Approx. 15.0 k] (33.1 lbs.) (excluding accessories)
– 151 –