Table of Contents
Advertisement
Setting the sync signal
The sync signal to be used by the system can be selected.
In external synchronization, it is synchronized with an external sync signal. (Genlock)
The Reference input signal is output using the loop-through method.
1
Select the <SYS> button → [SYSTEM] → [Video] tab.
2
Select an item in [Sync] in the [Reference] column.
f Select the sync signal.
[BB]
[BB Advanced]
[Tri-level sync]
[Internal]
[ST2059]
f This unit supports synchronization signals for field frequencies that are the same as those of the system format.
3
Check the display in [Gen Lock] in the [Reference] column.
f Check the Genlock status.
[Unlocked]
[Locked]
Other video signal settings
Setting the amount of delay in video effects
Check the amount of delay in background images or key images.
1
Select the <SYS> button → [SYSTEM] → [Video] tab.
2
Check the item in [BKGD]/[Key]/[DSK] in the [Latency] column.
[Minimum]
Network settings
For details on network settings, refer to "Network settings".
Chapter 8 System Menu — System settings
Black burst signal (vertical phase of 0H)
Black burst signal
When 59.94i or 59.94p is selected: Vertical phase of 90H
When 50i or 50p is selected: Vertical phase of 75H
Tri-level sync signal (vertical phase of 0H)
Synchronizes with an internal reference signal (INT).
This is the PTP synchronizing signal. Future support is planned.
Not synchronized with the external sync signal or internal reference signal.
Synchronized with the external sync signal or internal reference signal.
The video is not delayed.
– 125 –
Advertisement
Table of Contents
