Setting Output Signals; Assigning Output Signals - Panasonic Live Production Suite Series Operating Manual

Setting output signals

The rear of the Gateway Unit is equipped with SDI connectors for input and output.
f Each Gateway Unit can output 12G SDI signals to 6 systems.
f The allocation of output signals for each terminal is performed by selecting top menu <IN OUT> button → [OUT ASSIGN] → [Assign] tab.

Assigning output signals

Assign output signals to [SDI OUT 1] through [SDI OUT 12].
1
Select the <IN OUT> button → [OUT ASSIGN] → [Assign] tab.
2
Set the output signals to assign.
f Output signals that can be assigned are as follows.
ME1PGM, ME2PGM,
DSKPGM1, DSKPGM2
DSKPVW1, DSKPVW2
AUX1 - AUX16
MV1, MV2
ME1KEYPVW, ME2KEYPVW
ME1PVW, ME2PVW
DSKEXT1-1, DSKEXT1-2,
DSKEXT2-1, DSKEXT2-2
f For details on ME/DSK output signal settings, refer to "Setting the ME output and DSK output".
Chapter 6 Input/Output Signal Settings — Setting output signals
Outputs an image with the wipe, mix, key, downstream key or other effect to the switcher's main line output.
Preview output of DSKPGM1 and DSKPGM2. The background image can be selected from MEPGM or MEPVW shown
above.
Outputs the signal selected by the 16 lines of AUX buses ([AUX1] to [AUX16]).
Outputs the MultiView display signal. Multiple input and output signals are reduced and output to a single screen.
(page 110)
Outputs the preview signal exclusively for the key.
Outputs the preview signal for BKGD, KEY1, and KEY2 for each ME.
These output signals can be set by the user.
– 109 –