gefran QE1008-W SET Operating Manual page 25

10.4.1. Activating the system
First use of sensors
Before using the QE1008-W sensors for the first time, make sure that the supplied
display software is installed on the computer.
• Use the Sensormate App if on your PC is installed Windows 10.
(see section: „Sensormate App")
• Use the Inspectmate Software if on your PC is installed Windows XP/7/8/10.
(install the Inspectmate Software from USB-Stick)
Activating the system
1. Switch on all sensor pairs.
→ Press the button on the housing for 1 second.
→ The LED flash green.
2. Connect the wireless receiver to the USB port of the PC.
3. Start the display software on the PC.
→ The wireless receiver automatically connects
to all activated QE1008-W sensors.
→ If the wireless receiver is recognised by the
software, this is confirmed by "QE1008-W" in
the information display.
Subject to technical modifications
25