Preparation; Charging; Using The Usb Charging Cord (Supplied) To Charge The Earphones And The Charging Cradle - Panasonic RZ-S500W Operating Instructions Manual

Charging

The chargeable battery (installed in the unit) is not charged initially. Charge the battery before using the unit.
• Proper charging is not possible if there is dust or droplets of water on the terminal sections of the earphones or
charging cradle. Remove the dust or water droplets before charging.
Note
• Charge in a room temperature between 10 oC and 35 oC.
• It is not possible to turn the power on or connect to Bluetooth

Using the USB charging cord (supplied) to charge the earphones and the charging cradle

When the earphones have not been put into the charging cradle, the charging cradle itself is charged.
1
Use the USB charging cord (supplied) (b) to connect the charging cradle to a
computer (a).
• Charging of the charging cradle starts. The charging cradle LEDs light or blink (white) while the charging
cradle is charging. Charging is complete when they turn off.
• Check the direction of the USB charging cord terminals and plug in/out straight holding onto the plug. (It may
result in malfunction by the deforming of the terminal if it is plugged in obliquely or in wrong direction.)
2
Put the earphones into the charging cradle.
• Confirm the L side and R side of the earphones, and match the positions of the charging terminals on the
earphones with the terminal sections in the charging cradle. (Charging of the earphones will not start if the
positions do not match.)
• The way the earphone LEDs light when you put the earphones into the charging cradle depends on the usage
status.
Usage status
Charging for the first time (after
purchase)
Charging any time after the first time
(When there is still battery charge)
When the batteries are depleted (When
there is no battery charge at all)

Preparation



Earphone LED lighting/blinking patterns
The earphone LEDs light (red) about 5 seconds after you put the
earphones into the charging cradle.
When you put the earphones into the charging cradle, the
earphone LEDs light (red) about 3 seconds, then turn off. After
about 5 seconds, the earphone LEDs light (red) again.
• If the earphone LEDs do not light (red) again, the earphones are
fully charged.
The earphone LEDs light (red) about 5 seconds after you put the
earphones into the charging cradle.
10
®
devices during charging.