Operating With The Touch Sensors - Panasonic RZ-S500W Operating Instructions Manual

Operating with the touch sensors

You can operate the touch sensors on the earphones to change to the Bluetooth
®
control the Bluetooth
• Depending on the Bluetooth
functions may not respond or may operate differently from the descriptions below.
∫ List of operations available with the touch sensors
Function
Listening to music
Playback/pause
Raise the volume
Lower the volume
Forward a track
Back a track
Making a phone call
Receive a phone call
Reject a phone call
End a phone call
Change control of external
sounds
Start the voice assistant
Set to the Bluetooth
*
mode
Return to the factory settings
* With both earphone LEDs (L and R) blinking alternately in blue and red
Note
• You can also use just one side of the earphones independently. In this case, it is only possible to perform operations
available on the side you are using.
• A beep sounds to indicate that you have touched to reach either the maximum or minimum volume level.
device.
®
device or the app, even if you operate the touch sensors on the earphones, some
Touch sensor (L)
Touch once
Touch rapidly 3 times
Touch rapidly 2 times
Touch once while receiving the call
Touch and hold for about 2 seconds while receiving the call
Touch and hold for about 2 seconds during the call
Touch and hold for about
2 seconds
®
pairing (l 14, "Connecting a Bluetooth
(l 21, "Restoring to the factory settings")
Operation
–
–
–
®
device")
20
®
pairing mode, or remote
Touch sensor (R)
–
–
Touch rapidly 2 times
Touch rapidly 3 times
Touch and hold for about
2 seconds
–