Preparation; Charging; Turning The Power On/Off - Panasonic RP-HD605N Owner's Manual

Charging

The rechargeable battery (installed in the unit) is not charged initially. Charge the battery before using the unit.
Connect this unit to a computer using the
USB charging cord.
A : Power/pairing LED
B : USB charging cord (supplied)
• Check the direction of the terminals and plug in/out
straight holding onto the plug. (It may result in
malfunction by the deforming of the terminal if it is
plugged in obliquely or in wrong direction.)
C : Computer
• Turn on the computer in advance.
• The power/pairing LED lights in red when charging is
in progress. When charging is completed, the power/
pairing LED will go out.
• Charging will take approximately 4 hours from empty
state to fully charged.
Note
®
• The Bluetooth feature cannot be used when this unit is connected to a computer using the USB charging cord.
• Charge in a room temperature between 10 oC and 35 oC (50 oF and 95 oF).
• The power cannot be turned on while charging.
• Do not use any other USB charging cords except the supplied one. Doing so may cause malfunction.
• Charging may not be performed or may stop if the computer is in or switched to standby or sleep mode.

Turning the power on/off

In the power-off state, press and hold [Í/I ( )] of this
unit for approx. 3 seconds until the power/pairing LED
(blue) blinks.
• A guidance message will be heard, and the power/pairing LED (blue)
will blink slowly.
∫ To turn the power off
Press and hold [Í/I ( )] for approximately 3 seconds. A guidance
message will be heard, and the power will be turned off.
Note
• If the unit is not connected to a Bluetooth
automatically approximately 5 minutes after you have stopped using it. (Except for when noise cancelling is turned
ON.) ( l 17, "Auto power off")

Preparation

Right (R)
side
®
device, a guidance message will be heard and turn off the unit
9
B
A
Right (R) side
Power/pairing LED
[Í/I ( )]
C