Charging - Silvercrest SAS 7.4 LI D3 Operating Instructions And Safety Instructions

4) Push the wall plugs into the holes and then screw the wall bracket
into place using the screws .
5) You can place the nozzles on the accessories holder on the side .
6) Connect the mains adapter

Charging

NOTE
► Check to ensure that the on/off switch
position "0") before starting the charging process .
■ Place the handheld vacuum cleaner from above into the wall bracket
that the barrel plug
The charge indicator lamp
Important: The charge indicator lamp
■
handheld vacuum cleaner is charged enough to vacuum again . This does
not mean that all the batteries are completely charged . When the charge
indicator lamp
■ When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function) . Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter
■ Do not recharge the batteries again until the handheld vacuum cleaner's suc-
tion power becomes appreciably weaker and the charge indicator
lamp
NOTE
► If the battery is completely discharged, the appliance switches off and
the charge indicator lamp
60 seconds . Start charging the appliance .
► The handheld vacuum cleaner can also be charged directly via the mains
adapter
the wall bracket
plug
SAS 7.4 LI D3
slips into the socket on the handheld vacuum cleaner .
5
7
lights up green, the batteries are charged to around 80% .
7
.
4
flashes green .
7
7
. To do this, remove the barrel plug
4
and the cable from the cable routing . Insert the barrel
3
into the socket on the handheld vacuum cleaner .
5
to a mains power socket .
4
has been pushed back (to the
6
lights up red and the charging process begins .
lights up green once the
7
flashes green/red alternately for approx .
5
GB │ IE │ NI │ CY
firmly
3
so
3
with a slight twist from
│ 9 ■