Charging - Silvercrest 430722 2301 Operating Instructions Manual

2) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
3) Drill two holes about 54 mm apart. Use the wall bracket
holes, to ensure the correct spacing. The drill holes must be suitable for 5 mm
wall plugs.
4) Push the wall plugs
firmly into place using the screws
5) You can place the nozzles on the accessories holder on the side.
6) Connect the mains adapter

Charging

Note
► Check to ensure that the on/off switch
position 0) before starting the charging process.
■ Place the handheld vacuum cleaner from above into the wall bracket
that the barrel plug
handheld vacuum cleaner. The charge indicator lamp
charging process begins.
■ Important: The charge indicator lamp
handheld vacuum cleaner is charged enough to vacuum again. This does
not mean that all the batteries are completely charged. When the charge
indicator lamp
■ When charging is complete, which can take around 6 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter
■ Do not recharge the batteries again until the handheld vacuum cleaner's suc-
tion power becomes appreciably weaker and the charge indicator
lamp
Note
► Shortly before the batteries are completely discharged, the charge indicator
lamp
switch off. Start the charging process.
► The handheld vacuum cleaner can also be charged directly via the mains
adapter
wall bracket
5
into the socket on the handheld vacuum cleaner.
■ 10 │ GB │ IE
r
into the holes and then screw the wall bracket
5
slips into the charging socket on the underside of the
7
lights up green, the batteries are charged to around 80%.
4
.
7
flashes green.
7
flashes green for approx. 60-120 seconds. The appliance will then
4
. To do this, remove the barrel plug
3
and the cable from the cable routing. Insert the barrel plug
e
.
4
to a mains power socket.
6
has been pushed back (to the
7
lights up green once the
5
3
:
4
.
3
to mark the
3
3
7
flashes red and the
with a slight twist from the
SAS 7.4 LI E4
so